Before you break out the tools or packing tape, have you first tried a
Master Reset, RAM Clear or re-flash of the firmware?
73, Barry N1EU
On Wed, May 15, 2013 at 8:14 PM, Carl Moreschi <n4py3@earthlink.net> wrote:
Pull the front panel and spray all the cable connectors. Unplug each
connector, spray them, and then plug them back in and out at least 10 times
to clean them. There's at least 100 connections in there, each one with its
own symptom. That fixed mine when I had an intermittent problem. The fact
that the problem is intermittent points to a cable connection.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 5/15/2013 3:36 PM, John Huffman wrote:
The last two days I have had an intermittent problem with my Orion 565.
I have no receive audio or just white noise. When this happens no
transmit output over 1 watt. Screen shows proper tuning and mode
selections, but you can't hear anything or only hear white noise.
Any ideas before I send it in?
73 de K1ESE
John
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec