To: | rmcgraw@blomand.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] OT: THHN Wire in Germany |
From: | Richards <jrichards@k8jhr.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Fri, 26 Apr 2013 11:23:21 -0400 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On this description, my old wire wound guitar strings should prove worthy when constructing a short, high band antenna... Hhmmm... ------------------- K8JHR ---------------------------- On 4/24/2013 7:01 PM, Robert Mcgraw wrote: On the flexing point, correctly, there should be a steel center core messenger for longitudinal strength, then a clockwise wound layer of copper and then a counter clockwise layer of copper. The typical stranded THNN and such does not provide these properties. _______________________________________________________ ./ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400, Barry N1EU |
---|---|
Next by Date: | [TenTec] FW: N Type of connectors, Ron Boyk |
Previous by Thread: | Re: [TenTec] OT: THHN Wire in Germany, Robert Mcgraw |
Next by Thread: | Re: [TenTec] OT: THHN Wire in Germany, Rick - DJ0IP / NJ0IP |
Indexes: | [Date] [Thread] [Top] [All Lists] |