Davis RF has UHF connectors for 1/2" Heliax.
While they are not Andrews connectors, they are of high quality and work quite
well.
73,
Charlie N9CO
-----Original Message-----
From: Jerry R <jerry@daca.net>
To: Craig Thompson <craig@thompsonet.com>
Cc: SMC <smc@w9smc.com>; TenTec Reflector <tentec@contesting.com>; W9AML
group-email <w9aml@midlandsnetworking.com>; DX-IS <DX-IS@yahoogroups.com>
Sent: Wed, Apr 24, 2013 12:13 pm
Subject: Re: [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400
Craig,
Do you have a source for UHF connectors for LDF4-50A
I was told that Andrew does not manufacture those in UHF style anymore....
Maybe my supplier was wrong, or you have a different source to purchase new
ones...
and I would highly suggest the LDF4 also.... not to discount LMR-400, we use
that
on long runs on DXpeditions and its pretty good stuff
Jerry WB9Z
Craig Thompson <craig@thompsonet.com> wrote ..
> Hi Gary
>
> I would use the 1/2" Heliax. I use both and the outer jacket of the Heliax
> is superior to the LMR for both water and sun. It also has lower loss. I
> would use LMR400 UF or similar for the rotator loop. Use all UHF connectors
> for connections.
>
> 73, Craig K9CT
>
>
> On Wed, Apr 24, 2013 at 11:37 AM, GARY HUBER <glhuber@msn.com> wrote:
>
> > As I consider the materials required to replace my 30 year old tower,
> > rotor, antenna and cables, I have several like new runs on LDF4-50A
> > terminated with N-male which could run from my ground window (UHF female)
> > to the top of my 53 foot tower (60 feet max LDF4-50A cable run) where a
> > flexible low-loss 10 foot jumper would terminate on a new BN-4000 and new
> > TH-7 tribander. This configuration would require the 60 feet max LDF4-50A
> > cable run, two half inch N female to UHF male adapters, one UHF double
> > female and 10 feet of high quality RG8 cable as the jumper to the BN-4000.
> >
> > The alternative which I’m leaning towards as it seems less likely to have
> > connector/adapter loss and other potential problems is a single run of 75
> > feet of LMR-400 with factory terminated PL-259s between the BN-4000 and
> > ground window UHF female termination. My current installation is 60 feet of
> > RG-9913, a UHF double female adapter and a ten foot RG-8214 jumper.
> >
> > I know the half inch Andrews Heliax has a much lower loss figure (0.357 db
> > per 100 feet at 30MHz) for a given length versus the same length of LMR 400
> > (0.7 db per 100 feet at 30MHz) , but I’m thinking those three adapters (six
> > connection points for loss) and their potential problems make it a wash or
> > maybe the advantage goes to the 75 foot run of LMR-400.
> >
> > I’d be interested in any comments or experiences you might have on the
> > subject.
> >
> > 73 ES DX,
> > Gary -- AB9M
> >
> >
> >
> >
> >
> +-----------------------------------------------------------------+
> SMC Web Site: http://www.w9smc.com
> List Help: http://mail.w9smc.com/mailman/listinfo/smc_w9smc.com
> Submissions: smc@w9smc.com Problems? Contact: smc-owner@w9smc.com
+-----------------------------------------------------------------+
SMC Web Site: http://www.w9smc.com
List Help: http://mail.w9smc.com/mailman/listinfo/smc_w9smc.com
Submissions: smc@w9smc.com Problems? Contact: smc-owner@w9smc.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|