Hi Barry,
Had not thought about doing that as I was unsure when one might turn up.
Then again the schematic for the 244 may be exactly what I need to get on
with the project. If I am successful (big if) then I will share what I did.
Thank you for responding.
73's
Pete N6QW
--------------------------------------------------
From: "Barry N1EU" <barry.n1eu@gmail.com>
Sent: Tuesday, November 13, 2012 2:26 AM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Model 540 / 544 Question
Have you considered just adding a Model 244 digital display?
http://www.tentecwiki.org/doku.php?id=244
73,
Barry N1EU
On Tue, Nov 13, 2012 at 1:05 AM, N6QW <n6qw@jessystems.com> wrote:
Am looking at a project to upgrade a Model 540 to a Model 544 insofar as
the digital display feature. The AADE digital display kit (modified) is
what I am looking to use on the project. Before I reinvent the wheel or
plow really old ground, has someone done this before and are there any
source reference documents?
73's
Pete N6QW
As a ham, a day isn't is a day unless you solder your fingers together at
least once!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|