Re: [TenTec] 961 PS help

["Ralph" <w8bvh@sbcglobal.net>]

Thanks Bob,
Never thought of that. Too big of a hurry I guess.
Best regards,
Ralph Howes
W8BVH


----- Original Message ----- 
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 05, 2012 8:40 PM
Subject: Re: [TenTec] 961 PS help


> Squirt it with a wee bit of WD-40.  Likely just needs a "lube job"
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message ----- 
> From: "Ralph" <w8bvh@sbcglobal.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, November 05, 2012 7:33 PM
> Subject: [TenTec] 961 PS help
>
>
> > Greetings,
> > I have a 961 power supply and the on-off toggle switch is getting almost 
> > impossible to turn on or off. Does anyone know the correct switch for 
> > this supply? I have not checked anywere so far. Thought I would ask here 
> > before calling Ten Tec.
> > Thanks in advance for any help.
> > Best regards,
> > Ralph Howes
> > W8BVH
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec