TenTec
[Top] [All Lists]

[TenTec] LP-Pan and Ten Tec

To: Ten Tec Mailing List <tentec@contesting.com>
Subject: [TenTec] LP-Pan and Ten Tec
From: Eric Rosenberg <ericrosenberg.dc@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 02 Nov 2012 19:03:10 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thought this might be of interest. It's from the LP-Pan email reflector.

Enjoy!

73,
Eric W3DQ
Washington, DC

----------------------------

Re: Ham Radio Deluxe Bandscope
Fri Nov 2, 2012 5:55 am (PDT) . Posted by: "Larry Phipps" n8lp

I am planning to add TenTec support to LPB2 as soon as I can get to it.
LPB2 is the "glue" which holds it all together for all rigs except
TenTec. It allows you to use multiple loggers, drive s SteppIR, etc.
There are some other ways to tie it all together, but not easy. For
instance, N4PY connected to the rig, and linked to LP-Bridge will do all
the same stuff as you would have with a supported rig. A virtual com
program like VSPE is also needed. You can find more about this option at
N4PY's website.

For a relative display use PowerSDR/IF or NaP3 to provide the realtime
pan display. You can set it up so the the center is "0" kHz, and the
frequency scale on either side is relative out to + / - 96 kHz.

73,
Larry N8LP

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] LP-Pan and Ten Tec, Eric Rosenberg <=