Okay,
i have one of the chips, took it out, but can replace it.
however, i'd guess that the chip has to be left in the rig after the
corrections?
mike
wb8vge
On Oct 21, 2012, at 12:30 PM, Carl Moreschi wrote:
> It's the trimmers on each band crystal. They are difficult to change. If you
> are using my N4PY Omni V.9 chip, there's a way to calibrate each band from
> the front panel without even removing the covers.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 10/21/2012 12:26 PM, Mike Bryce wrote:
>> Guys,
>>
>> working on a Omni V. All back together and receiving and transmitting just
>> fine.
>>
>> However, the display is off, just a tad, and I can't find anyplace in the
>> manual on how to correct the error
>>
>> MIDCARS at 7.258 is hear best on 7.258.11
>>
>> Same thing on WWV at 10.000.
>>
>> So, anyone knows were that correction is made?
>>
>>
>>
>> Mike, WB8VGE
>> SunLight Energy Systems
>> The Heathkit Shop
>> http://www.theheathkitshop.com/
>> J e e p
>> o|||||||o
>> Note: No trees were killed in the sending of this message, but a large
>> number of electrons were terribly inconvenienced
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|