It's the trimmers on each band crystal. They are difficult to change.
If you are using my N4PY Omni V.9 chip, there's a way to calibrate each
band from the front panel without even removing the covers.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 10/21/2012 12:26 PM, Mike Bryce wrote:
Guys,
working on a Omni V. All back together and receiving and transmitting just fine.
However, the display is off, just a tad, and I can't find anyplace in the
manual on how to correct the error
MIDCARS at 7.258 is hear best on 7.258.11
Same thing on WWV at 10.000.
So, anyone knows were that correction is made?
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
Note: No trees were killed in the sending of this message, but a large number
of electrons were terribly inconvenienced
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|