TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II model 586 questions

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II model 586 questions
From: mhoff@wisperhome.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 05 Oct 2012 19:12:59 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Pete - that should take care of it - I've replcd a few....
just be sure to look at the date stamp to be sure it's
not old stock. I believe Gary had a good link to purchase that chip..
Good luck with it
73 Mike W9IFR


On 05.10.2012 11:57, Peter Bertini wrote:
Thanks Mike... that confirms my suspicions. I'd also guess the Dallas time chip has an internal battery for the clock. Those Dallas chips seem to run forever. I'd wonder if anyone has opened one up to see if it is feasible to
replace the internal battery?

The T voltage Omni VI QSK keying mod for non tech amps has been discussed in the past. It works fine with my converted SB-220. I'd think the control boards and the T voltage timing would be the same between the Omni VI and
Paragon II, but I was hoping that someone had tried it.

Pete
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>