The reader is functional with the existing set up but the added level of noise
is interfering with the reader getting a clean audio signal.
On Apr 25, 2012, at 8:29 AM, Rick - DJ0IP / NJ0IP wrote:
> Steve,
>
> Check the requirements of your external reader.
> It may be that it is expecting a signal from the "Line Out" of the radio,
> which the Argosy does not have (yet).
> You may need to tap into an earlier stage of the Argosy's audio, and indeed
> run a shielded cable, like RG-174 to the Spare Jack on the back.
>
> Later Ten-Tec radios had this Line Out available on the Accessory Jack(s).
>
> 73
> Rick, DJ0IP
>
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Stephen Roberts
> Sent: Wednesday, April 25, 2012 2:21 PM
> To: tentec@contesting.com
> Subject: [TenTec] Additional audio out for Argosy 525
>
> GM,
>
> I want to add an additional audio out for my Argosy so I can feed it to an
> external keyer/reader. I originally ran a wire from the phone jack to one of
> the spare RCA jacks on the back of the unit, but now have an added level of
> white noise that is always there even if the AF is turned all the way down.
> I'm thinking that that wire needs to be sheilded?
>
> Steve
> W1SFR
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|