Since I run remote, I haven't looked at the display, but I do agree that the
distortion problem is gone in 566v3.029. Also, the NR seems to have a
better range of control than with earlier versions.
Ron Castro
Chief Technical Officer
Results Radio, LLC
N6IE
www.N6IE.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Mike Stricker
Sent: Saturday, April 14, 2012 3:41 PM
To: tentec@contesting.com
Subject: [TenTec] 566 Orion II Firmware Version V3.029 ---Comments
Hi,
I was wondering if anyone noticed that the spectrum display reads correctly
on USB but is off a bit for CW and LSB modes. When a signal on USB is tuned
in properly, the peak on the display is right at '0'. The peak is a bit to
the left of '0' for CW and LSB...about 1.6KHz for LSB. It reads low for CW
and depends on whether the mode is UCW or LCW.
The audio distortion issue seems to have been resolved.
Thanks John.
Mike, WA1SEO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|