I guess I side with JB on this one. I have solved so many problems
with noise on the input (be it a guitar amp, a ham radio, a tape
recorder, or even connecting sound cards between different computers,
etc.) by finding the point where an extra ground to the equipment
chassis of the respective devices kills it. Of course you don't always
want to solve the problem (e.g., an electric guitar may not sound quite
the same afterwards, and maybe you will accept a certain amount of
buzzing to keep your signature the sound...) but often a spare wire to
ground cures it.
I cannot help but think that is better than trying to choke it all off
with numerous ferrite beads.
Just MY take...
======================== K8JHR ========================
On 4/4/2012 11:37 PM, Ron Castro wrote:
> Of course, the whole shack should start with a good, clean 'star' ground and
> elimination of ground loops, and if the problem persists, ferrites on each
> of the suspect conductors into and out of the transceiver.
>
___________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|