On 1/31/2012 1:06 PM, kc9cdt@aol.com wrote:
> I really do hope they made some improvements as well as adding the
> audio peak function in V3.
> 73,
> Lee
>
>
>
> -----Original Message-----
> From: Rsoifer<Rsoifer@aol.com>
> To: tentec<tentec@contesting.com>
> Sent: Tue, Jan 31, 2012 12:31 pm
> Subject: Re: [TenTec] RX366
>
>
> In a message dated 1/31/2012 3:55:24 PM GMT Standard Time,
> kc9cdt@aol.com
> writes:
>
>
>> I don't notice that problem, but I don't use the NB, just the NR.
> Wait
> for the V3 firmware. For me, the NR (2.044A) is very good on CW, not
> so good
> on SSB.
>
> 73 Ray W2RS
>
> I find the NR is not very good here on the OII. Also the NB causes lots
>> of clicking sound when a strong signal is ...well maybe within 10 KC
> or
>> so.
>> I really wish it was better....so...I rarely find an instance that it
>> helps...
>> Maybe I need to tweek some settings while using it??
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
I would really like to see some improvement to the sweep display on the
Orion II as promised ! John Molenda kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|