| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Re. [Ten Tec] Grounds How to Bond? |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 24 Jan 2012 16:55:30 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
We do use bolted and clamp connections in bonding our flat straps to our bus strap. Carefully cleaned and even using some no oxidizing compound or other protection from corrosion. The posted answer about bonding was a good general definition. You can also find rods thermally bonded to ground conductors by other than mechanical clamping. This is done by Thermite welding, where metal is melted at the bond. Stuart Rohre K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Re. [Ten Tec] Grounds, Jim Brown |
|---|---|
| Next by Date: | Re: [TenTec] Eagle roofing filters, Rodney |
| Previous by Thread: | Re: [TenTec] Re. [Ten Tec] Grounds, Jim Brown |
| Next by Thread: | Re: [TenTec] Re. [Ten Tec] Grounds, Ten-Tec Amateur Radio Sales |
| Indexes: | [Date] [Thread] [Top] [All Lists] |