I will, although I'd wonder why it would suddenly change...
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of k3miy@csonline.net
Sent: Monday, January 16, 2012 7:52 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni VI+/960 PS down
Ron
Check the power supply trip voltage pot. Is the voltage above about 15
volts? It may need adjustment.
Ron
K3MIY
Quoting Ron Notarius W3WN <wn3vaw@verizon.net>:
> Had something unexpected happen with my Omni VI+ & 960 power supply
earlier
> today.
>
> Sequence of events:
>
> Omni had been on for awhile listening to some PSK-31. Worked some DX on
12,
> then shut it down, followed by the 960 (had an appointment to go to).
>
> When I went to power it back up later, turned on the 960 first. LED
blinked
> a couple of times. Omni did not power back up. Turned everything off.
Now
> the 960 does not appear to power up at all; no light on the LED, no
voltage
> output that I can measure.
>
> Checked the fuse; it appears to be fine. So my immediate guess is that
> something in the PS popped to protect the fuse... although I'm not 100%
> certain, since I don't have a cable available to run the Omni from my
Astron
> PS (it's ordered, but won't be here for a few days. Of course.)
>
> Sound familiar to anyone?
>
> 73, ron w3wn
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
-------------------------------------------------------------------
This mail sent through CSOnline Webmail http://webmail.csonline.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|