SWEETWATER ALSO HAS A 10 DB PAD WITH XIL CONNECTIONS TO PUT IN LINE WITH
XIL 19.95 NO SHIPPING CHARGE CONTACT 1-800-222-4700 EX-1295 TALK TO CORY.
-----Original Message-----
From: Richards
Sent: Tuesday, December 06, 2011 3:36 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Yamaha CM-500 boomset use with Orion II?
Works fine. Use a 10 dB attenuator like this to keep the mic from
being too hot into the circuit. Your AGC will work better if your mic
setting is set at about 35-55 - but without the attenuator, it sometimes
needs to be set as low as 2-3% and that crowds the AGC so that it is
always on or always off, and has little room for flexing. You want
the AGC to come on occasionally on voice peaks, but if your mic is so
hot you gotta set the mic input volume down as low as 2 or 3 percent, it
has little room to flex and may always be on or come on too often.
http://www.sweetwater.com/store/detail/MicroTrackPad
It has been awhile since I looked at Jim Brown's article on audio
interfacing, and cannot recall if he works in an attenuator pad or not,
but it is worth considering.
======================= James -K8JHR ==========================
On 12/6/2011 1:14 PM, amsctalx@comcast.net wrote:
the use of my beloved CM-500 with the Orion II. .... and Omni VII ....
====================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|