Nope, Orion's TX bandwidth at 3900hz setting is actually 6Khz - I've
measured it. I wouldn't go this wide if the band was crowded at all,
but on 10M stations are typically spaced every 10Khz.
Barry N1EU
On Sat, Dec 3, 2011 at 4:05 PM, Clayton Brantley <clayton_n4ev@yahoo.com> wrote:
> Barry: Watch your bandwidth! AM Signals should be no more that 6khz wide
> and you are 7.4 khz with that 3.9 khz setting!.
>
> Clayton N4EV
>
>
>
> ________________________________
> From: Pumbaa <pinkertontommrs@bellsouth.net>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Saturday, December 3, 2011 10:52 AM
> Subject: Re: [TenTec] Orion II AM settings
>
> Does the Orion II transmit full AM, that is both sidebands?
> ****************************************************
> -----Original Message-----
> From: Rsoifer@aol.com
> Sent: Saturday, December 03, 2011 9:35 AM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Orion II AM settings
>
> Hi Barry,
>
> Yes, you're right about the bandwidth. I had set it to 2100 because I had
> a report that it improved the modulation depth. I didn't quite understand
> why, but as you said I let the on-air report be my guide.
>
> This morning, however, I opened it up all the way (3900) and got a few more
> reports. They all liked my audio, both quality and quantity. So, 3900 it
> will stay, on AM anyway.
>
> Tnx, and CU on 10.
>
> 73 Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|