Barry: Watch your bandwidth! AM Signals should be no more that 6khz wide
and you are 7.4 khz with that 3.9 khz setting!.
Clayton N4EV
________________________________
From: Pumbaa <pinkertontommrs@bellsouth.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Saturday, December 3, 2011 10:52 AM
Subject: Re: [TenTec] Orion II AM settings
Does the Orion II transmit full AM, that is both sidebands?
****************************************************
-----Original Message-----
From: Rsoifer@aol.com
Sent: Saturday, December 03, 2011 9:35 AM
To: tentec@contesting.com
Subject: Re: [TenTec] Orion II AM settings
Hi Barry,
Yes, you're right about the bandwidth. I had set it to 2100 because I had
a report that it improved the modulation depth. I didn't quite understand
why, but as you said I let the on-air report be my guide.
This morning, however, I opened it up all the way (3900) and got a few more
reports. They all liked my audio, both quality and quantity. So, 3900 it
will stay, on AM anyway.
Tnx, and CU on 10.
73 Ray W2RS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|