Jerry,
It always helped me to say bad things. Actually, I just checked the allen
wrenches I used for that (don't have a Corsair II any more) and they are all
5/64 and smaller. And, the right one can be a rascal (you may substitute one of
the bad words here) to get into the set screw. Just keep trying with the tiny
wrenches. You're on the right track
Dave
WA3F
----- Original Message -----
From: "Jerry Haigwood" <jerry@w5jh.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, October 20, 2011 10:18:29 PM
Subject: [TenTec] How do you remove the Corsair II Tuning Knob?
Folks,
I am trying to remove the main tuning knob from the Corsair II.
Someone told me the set screw took a 1/16 inch hex wrench (AKA allen).
However, I have been unable to get the 1/16 inch Allen wrench to fit into
the set screw. Were there any other set screws used? Is there a trick to
getting the knob off (you know, stand on your head with your tongue hanging
out the left side of your mouth while whistling Dixie)? Dunno, I am about
to say bad things..
Jerry W5JH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|