TenTec
[Top] [All Lists]

Re: [TenTec] Orion Display and Power Distribution Board

To: tentec@contesting.com
Subject: Re: [TenTec] Orion Display and Power Distribution Board
From: kc9cdt@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 12 Jan 2011 17:57:38 -0500 (EST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I would call Paul Clinton TT service mgr and ak about this..or complain 
about this????
That shoud not happen. I wander how many tey had go out that way>???
73,
Lee, KC9CDT



-----Original Message-----
From: Heinz Dietmar Karl <h-d.karl@t-online.de>
To: tentec <tentec@contesting.com>
Sent: Wed, Jan 12, 2011 4:48 pm
Subject: [TenTec] Orion Display and Power Distribution Board


Hallo Orion users,
2 weeks ago I`ve got an Orion1. It was announced to be full ok.
But as I switched it on , I saw the display was a little dark in the
upper left corner
and was flickering during transmission.
After a discussion with the former owner i was looking for the reason.

After studying the schematics and some measurements I found the reason .
The +5volts- voltage on the power distribution board A9 is unstable.
During transmission and by changing the power voltage e.g. the
5V-voltage alternates between 5 and 4,4 volts.

At first I tried to get an new board . But it was not on stock at Ten 
Tec.
Then I found this forum here and could learn what has happend before
with some failures around the unstable 5 volts.

But changing the recommended board-capacitors brought no better 
results..
Then I saw a difference between the board schematic and the circuitry 
on
my A9 board:
On my board the upper PNP -transistor was not the original type TO220P
NTE 378.
Ten Tec had used -how long?- another type BD246C .

Because this one is a TO3P Type and not fittable onto the bord , it was
mounted very carefully-like production people do it-
via 8cm long wires beside the A9 board on the al -case.

I am very sure this outsourced transistor has worked in my Orion since
it has left the production.
( Serial Nr. 10C 10584  in 2005)

I ordered- over night- the the original NTE 378 from a semiconductor
dristributor, placed it next morning
within 15 minutes directly onto the board and it worked perfectly.

see http://www.qrz.com/db/DJ8LX

The +5volts are stable under all conditions .
Now I am very happy with my Orion.

best 73
Heinz , DJ8LX


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>