Yes, if it's not trying to transmit on two frequencies, the problem is most
likely on the BPF board. Otherwise, it's probably one of the switching
diodes.
Should have put all this in one e-mail. Got a bad head cold. Sorry.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
To: <tentec@contesting.com>
Sent: Saturday, November 27, 2010 7:22 PM
Subject: Re: [TenTec] omni 6+/ power issue
> K6 and K7 switch 20 meters, K2 and K3 switch 10/12.
>
> 73, Jerry, K0CQ
>
> On 11/27/2010 5:28 PM, CSM(r) Gary Huber wrote:
>> Wayne,
>>
>> He didn't say how much to repair but I'd bet by the time you pay to ship
>> it
>> to TT, tech labor, parts, and return shipping, you'll have $150 invested.
>>
>> Here is the relevant part of the message I received....
>>
>> I called the phone number you sent me for Ten Tec service and they had me
>> mail the radio... After week or so
>> they returned the radio, they replaced K6&K7 #32103 low pass board ,
>> cleaned
>> and aliganed as needed.
>> Radio working fine....
>>
>>
>> 73 es DX,
>>
>> Gary - AB9M
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|