Thanks Gary, I really don't want to send it to TT, but may have to do that. Do
you know how much it cost to fix?
Wayne
________________________________
From: CSM(r) Gary Huber <glhuber@msn.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Sat, November 27, 2010 1:14:51 PM
Subject: Re: [TenTec] omni 6+/ power issue
My Omni VI+ which I sold last summer apparently had this symptom on one band
and was sent to TT by the new owner for repair of the band pass board.
73 es DX,
Gary - AB9M
-----Original Message-----
From: Wayne Dial
Sent: Saturday, November 27, 2010 10:28 AM
To: tentec@contesting.com
Subject: [TenTec] omni 6+/ power issue
My OMNI 6+ has a power issue on 20m and 17m, it drops to 50w output on 20m
and
15w on 17m. All other bands are okay. I've checked the output of the L.O.
Mixer
board, port 26, across a 50 ohm load. 160m through 40m, the the output is
800
mvpp and and drops to 100mv on 20m and up. I don't think it is the output
filters of the PA because 20m and 17m don't share the same filter. The L.O.
Mixer is nested below another board so I can not make any measurements on
that
board other than ohm meter readings. Has anyone seen this before?
Thanks,
Wayne/w8aju
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|