I have a similar problem with my Orion I, but the problem is not noticeable
on bands below 18 mhz. As I turn up the power toward 100, the power meter
does a little hiccup and then the red ALC light goes out, and power doesn't
increase as I turn the multi knob further. Also, I have distorted audio,
and the speech processor is very distorted, and also reduces power output
when turned on.
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Dr. Gerald N. Johnson
Sent: Friday, November 12, 2010 7:27 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Orion I, reduced output power ???
On 11/12/2010 6:13 PM, Denton wrote:
> Check power connector and fuse holder?
Prime suspects. Check the voltage IN the radio under load. It probably
needs 13.8 volts for full power.
73, Jerry, K0CQ
> ----- Original Message -----
> From: "Rick - NJ0IP / DJ0IP"<Rick@DJ0IP.de>
> To: "'Discussion of Ten-Tec Equipment'"<tentec@contesting.com>
> Sent: Friday, November 12, 2010 4:09 PM
> Subject: [TenTec] Orion I, reduced output power ???
>
>
>> A friend of mine in DL has trouble with his Orion I.
>>
>> The output power is now at about 85 watts.
>>
>> This is independent of band.
>>
>> Small changes in the 13v supply has no influence on the power.
>>
>>
>>
>> He does not know if this happened all at once or just started to decay
>> over
>> time.
>>
>> I have advised him to try a second watt meter, dummy load, change coax,
>> etc., just to be sure it is the radio and not something else.
>>
>>
>>
>> Grateful for any ideas or tips where we could look.
>>
>>
>>
>> Tnx
>>
>> 73
>>
>> Rick
>>
>>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|