Hi Gary , thanks for your help . Will I a computer to run the 1500 ?
or just the monitor to show the panadapter ?
On 10/1/2010 3:02 PM, CSM(r) Gary Huber wrote:
> John,
>
> I think the easiest way is to contact TenTec and ask for the cables for the
> AUX Receiver modification for the 588. (No soldering or drilling required)
> Then purchase a FLEX 1500 (or similar multiband SDR).
>
> Hook up the SDR (receive only) to the 588's AUX Antenna terminals (formerly
> the two spare phono jacks on the rear of the 588) and control both with DXLab
> Commander.
>
> The FLEX 1500 will provide a 48 kHz wide real time Panadapter.
>
> Doesn't get much easier; no soldering, no drilling, no programming although a
> computer and screen are needed to display the Panadapter.
>
> 73,
>
> Gary - AB9M
>
>
> --------------------------------------------------
> From: "John Molenda"<brazos@rochester.rr.com>
> Sent: Friday, October 01, 2010 12:48 PM
> To: "TEN TEC DISCUSSION"<tentec@contesting.com>
> Subject: [TenTec] Omni VII
>
>> Hi All , I would like to know if there is a easy way to hook up a pan
>> adapter to the omni 7 radio . /are we waiting for Ten/ /Tec to create a
>> pan adapter for this radio ?/ has anyone used the P3 Elecraft
>> pan-adapter with this rado . I want to make my next radio one with a
>> pan-adapter and very much like the omni VII . Thanks John Molenda kb2huk
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|