The trouble is not with it worked the same with keyspan adapter. the troudle
is with tentec .
--------------------------------------------------
From: "ROD" <w3krq@dejazzd.com>
Sent: Monday, July 12, 2010 6:45 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] DOWN LOADS
> I am up to com21 can reset tentec says this adapater should work great.
> well it does not.
>
> --------------------------------------------------
> From: "Ed" <w3nr@comcast.net>
> Sent: Monday, July 12, 2010 6:30 PM
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Subject: Re: [TenTec] DOWN LOADS
>
>> On 07/12/2010 06:16 PM, Richards wrote:
>>> Are you using the TenTec Serial - USB adapter? If so, some little
>>> effort to get the latest drivers to work should get the click. You may
>>> need to remove them
>>> completely before re-installing the latest drivers. Sometimes it is
>>> just a matter of the computer seeing the hardware as com 5 or 6 or 8 or
>>> higher than the usual com 1-4 software is used to seeing and adjusting
>>> that assignment helps
>>> get the software to see the device.
>>>
>>> Good luck. ===================== James - K8JHR ================
>>
>> You just gotta love Linux.
>>
>> ed W3NR
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|