I am up to com21 can reset tentec says this adapater should work great.
well it does not.
--------------------------------------------------
From: "Ed" <w3nr@comcast.net>
Sent: Monday, July 12, 2010 6:30 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] DOWN LOADS
> On 07/12/2010 06:16 PM, Richards wrote:
>> Are you using the TenTec Serial - USB adapter? If so, some little
>> effort to get the latest drivers to work should get the click. You may
>> need to remove them
>> completely before re-installing the latest drivers. Sometimes it is
>> just a matter of the computer seeing the hardware as com 5 or 6 or 8 or
>> higher than the usual com 1-4 software is used to seeing and adjusting
>> that assignment helps
>> get the software to see the device.
>>
>> Good luck. ===================== James - K8JHR ================
>
> You just gotta love Linux.
>
> ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|