I would think you could run 100 watts in a contest WITH THE TENTEC FAN MOD
( $49 USD ) ON THE HEAT SINK! Another option would be a computer fan behind
the rig and one behind the power supply on some kind of rubber pad to keep
the noise down blowing onto the heat sinks! Ah, the smell of hot
transformers in the MORNING!
Walt K8CV Royal Oak, MI.
----- Original Message -----
From: <k3miy@csonline.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, July 01, 2010 8:33 AM
Subject: Re: [TenTec] Omni V power limits
> Bob
>
> For 100% duty cycle, run no more than 50 watts, unless you have good
> ventilation.
>
> Ron
> K3MIY
>
> Quoting Bob Towers <mm0rkt@gmx.com>:
>
>> I run a lot of digital modes and normally keep the power below 50 watts.
>> Just occasionally - ie in contests - I need a little more power,
>> especially using RTTY.
>>
>> What's the maximum power I could run using RTTY and, say MFSK, which - I
>> think - is a 100% duty mode?
>>
>> 73
>>
>> Bob
>> MM0RKT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
>
>
> -------------------------------------------------------------------
> This mail sent through CSOnline Webmail http://webmail.csonline.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|