Also, make sure that the update program is using the right COM port to
reach the radio. That would normally be the same COM port you're using for
CAT functions.
GL,
Ray W2RS
In a message dated 6/22/2010 5:13:15 P.M. GMT Standard Time,
wb9hla@comcast.net writes:
Make sure all of the other programs are shut down then try to update.
Gene
WB9HLA
----- Original Message -----
From: "RM" <royalct@myfairpoint.net>
To: <tentec@contesting.com>
Sent: Sunday, June 20, 2010 19:18
Subject: [TenTec] Orion ll Firmware 2.044A Will Not Load
> Current Firmware Version installed is 2.06b14
>
> In trying to install 2.044A, I consistently receive the error
> Communications
> with the radio failed, and so on. I'm using a USB to Serial Port
> converter
> which has been running with this radio without any problems. In fact, I
> loaded 2.06b14 using this setup.
>
> I don't believe it's the USB-to-Serial converter, since I control the
> radio
> and logging functions with DxBase 2007 without any issues. (baud rate
set
> to 57600, Word Length set to 8, Stop Bits set to 2, and assigned to
> comport
> 5). I've not had any problems loading the previous versions with the
> USB/Serial converter, or any problems with DxBase at the above settings.
>
> Any suggestions would be greatly appreciated.
>
>
> Ron / NU1U
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|