It sounds like you're using an 'original' Orion, not an Orion II. Firmware
version 2.06x is for the 'original' Orion (565), so you won't be able to
load version 2.044A since it's only for the Orion II (566).
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "RM" <royalct@myfairpoint.net>
To: <tentec@contesting.com>
Sent: Sunday, June 20, 2010 4:18 PM
Subject: [TenTec] Orion ll Firmware 2.044A Will Not Load
> Current Firmware Version installed is 2.06b14
>
> In trying to install 2.044A, I consistently receive the error
> Communications
> with the radio failed, and so on. I'm using a USB to Serial Port
> converter
> which has been running with this radio without any problems. In fact, I
> loaded 2.06b14 using this setup.
>
> I don't believe it's the USB-to-Serial converter, since I control the
> radio
> and logging functions with DxBase 2007 without any issues. (baud rate set
> to 57600, Word Length set to 8, Stop Bits set to 2, and assigned to
> comport
> 5). I've not had any problems loading the previous versions with the
> USB/Serial converter, or any problems with DxBase at the above settings.
>
> Any suggestions would be greatly appreciated.
>
>
> Ron / NU1U
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|