Thanks Ed,
The 311 used for the Orion apparently wouldn't work for the Omni VII which
provides band information via frequency from its serial port. There are
other commercial solutions but I believe using DXLab Suite Commander, a
device table for the computer parallel port, a 6' M/F DB-25 cable, and a
ULN2803 may be the most economical solution in my case and will work for
those with Orions (and 253s) running DXLab Suite.
73,
Gary - AB9M
--------------------------------------------------
From: "Edward Feustel" <efeustel@hughes.net>
Sent: Tuesday, June 15, 2010 2:31 PM
To: <tentec@contesting.com>
Subject: Re: [TenTec] 253 and Orion bandswitching
> An all Ten Tec solution is available for the Orion. It may also work on
> the
> Omni VII. I have it working on my system now.
>
> Ten Tec makes (and sold me) a 311 converter that converts the signals
> output from the Omni into the band signals for the 253. The Ten Tec cable
> lacks a wire for one band region, but Larry's Cables will provide a
> cable that performs
> the function.
>
> You can contact me for further details or look back at the archive where
> I have described this a few times.
>
> Ed, N5EI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|