Darn....I noted the galactic mass ion shift....and had no idea what caused
it.
Obviously your test of the radio affected the whole galaxy.
Please be more carefull !!
LOL :)
((For the humor impaired....this is a joke))
73 de Gary, AA2IZ
----- Original Message -----
From: "Martin Sole" <hs0zed@csloxinfo.com>
To: "'Ron Castro'" <ronc@sonic.net>; "'Discussion of Ten-Tec Equipment'"
<tentec@contesting.com>
Sent: Saturday, June 12, 2010 10:41 AM
Subject: Re: [TenTec] Orion 2 Firmware 2.044A PTT
>I just got my Orion 565AT back on line after the DSP board serial port died
> on me. Turns out the chip capacitors that produce the negative volts had
> gone bad. Ten-Tec kindly fixed the board I had shipped to them and even
> more
> kindly charged me $140 for the fix but I'm far from complaining, indeed
> I'm
> so delighted they would take just the module, that's a radio company I can
> work with.
>
> Having got it working I thought I would have a look at the AM transmit
> signal. Bear in mind this is a 565 not a 566 but likely similar in the way
> they do AM. Just on a power meter, not got it hooked to the service
> monitor
> as yet. Key down on AM it reads about 16 watts on a Bird 43 but with
> speech
> the Bird rises to about 24 watts. The Bird 43 does not respond to the
> modulation, only the carrier so it seems likely that some sort of
> controlled
> carrier is being implemented.
>
> 80 watts to 100 watts is about 0.95dB, Accounting for metering variations,
> modulation variations, temperature, moon phase, galactic mass ion shift,
> I'd
> say (maybe) near enough. Watts(sic) 0.95dB amongst friends?
>
> Martin, HS0ZED
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Ron Castro
> Sent: 12 June 2010 07:03
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A PTT
>
> I'm seeing 14.5 Watts with no modulation and mod peaks 60 to 80 Watts.
>
> Ron N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: <Rsoifer@aol.com>
> To: <tentec@contesting.com>
> Sent: Friday, June 11, 2010 1:16 PM
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A PTT
>
>
>> John,
>>
>> I don't have a true peak-reading wattmeter, so I can't measure the PEP
>> output. Jim may be right about controlled-carrier; I can't tell. When
>> using
>> TUNE and PWR, I get 95 watts, but only 11 watts with PTT and no speech.
>>
>> 73 Ray
>>
>>
>> In a message dated 6/11/2010 7:01:47 P.M. GMT Standard Time,
>> wb4qda@yahoo.com writes:
>>
>> Ray
>> When I speak into the Micrphone with the mode set to AM ,I modulates
>> up
>> to 80 watts .Tune is 21 watts and tune then the PWR I get 95 watts
>> output.
>> 73
>> John
>>
>>
>>
>> ----- Original Message ----
>> From: "Rsoifer@aol.com" <Rsoifer@aol.com>
>> To: tentec@contesting.com
>> Sent: Fri, June 11, 2010 10:38:22 AM
>> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>>
>> John,
>>
>> Funny thing about that. With the mode set to AM, when I hit Tune and
>> then
>> Pwr I get full output like you did, but if I hit the PTT button instead,
>> all I get is 11 watts on the Bird. It worked fine with 2.041XT.
>>
>> 73 Ray
>>
>>
>>
>>
>> In a message dated 6/11/2010 3:22:43 P.M. GMT Standard Time,
>> wb4qda@yahoo.com writes:
>>
>> Ray
>> I just tested my O2 on AM max output was 80 warrs on an Alpha watt
>> meter
>> also about the same reading on a LP-100A watt meter with the Power set
>> to
>>
>> 100%
>> using the new fearmware version 2.044A
>> 73
>> John wb4qda
>>
>>
>> ----- Original Message ----
>> From: "Rsoifer@aol.com" <Rsoifer@aol.com>
>> To: ronc@sonic.net; w5pny@arrl.net; tentec@contesting.com
>> Sent: Fri, June 11, 2010 8:36:18 AM
>> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>>
>> Ron,
>>
>> The NR problem has been fixed (!) but the old low-output problem on AM
>> is
>>
>>
>> back. Mine measures 11 watts carrier power, max. It worked fine with
>> 2.041XT.
>>
>> 73 Ray W2RS
>>
>>
>> In a message dated 6/11/2010 2:17:05 A.M. GMT Standard Time,
>> ronc@sonic.net
>> writes:
>>
>> I have adjusted the "Wish List" for the Orion II to reflect the newest
>> version of the firmware. It's at www.N6IE.com
>>
>> Ron N6IE
>> www.N6IE.com
>>
>> ----- Original Message -----
>> From: "Harry G McGavran Jr" <w5pny@arrl.net>
>> To: <tentec@contesting.com>
>> Sent: Thursday, June 10, 2010 5:50 PM
>> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>>
>>
>>>
>>> With this one I can set the side-tone level all the way
>>> up to 65 before the pops begin, and by the time one
>>> gets past 80 on towards 99 the distortion on the
>>> side-tone is still really bad -- BUT -- for me at
>>> least, levels are 50-60 are all I need and that is
>>> now distortion free, at least with a 610 Hz sidetone
>>> which is the only one I tested or use. I also am
>>> using the speaker and not headphones for this.
>>> Since one gets the side-tone every time the SPOT
>>> button is used, the side-tone distortion was really
>>> objectionable with 2.043B.
>>>
>>> The NR seems better too, but most all the time I don't
>>> really need it -- and it's nice not to have artifacts that
>>> sound like NR action on the side-tone which the side-tone
>>> is set to 50-60.
>>>
>>> There are a few CAT wierdnesses here and there, but the reliability
>>> of sending a strings of "*" commands seems better.
>>>
>>> Unless something else crops up, I think I can live with this
>>> release...
>>>
>>> 73 --
>>>
>>> Harry, W5PNY
>>>
>>>
>>>
>>>
>>>
>>> --
>>>
>>> Harry G. McGavran, Jr.
>>>
>>> E-mail: w5pny@arrl.net
>>>
>>>
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|