The best monitor for output and modulation is an oscilloscope. With it,
you can see carrier level changes and overmodulation, both upward and
downward. The 100 watt linear will start to clip upward modulation peaks
a bit above 100 watts (possibly set by ALC driven by output power peaks.
If downgoing modulation cuts off the carrier, that also makes splatter
and when detected in the AM receiver sounds just like clipping because
the audio envelope IS clipped.
73, Jerry, K0CQ
On 6/11/2010 11:00 AM, Martin Sole wrote:
> Not sure what the power 'should be', but a transmitter with a pa rated for
> 100 watts pep should give about 25 watts carrier when the ptt is pressed. 25
> watts of carrier plus 100% modulation would be 100 watts pep, the maximum
> the pa is capable of.
>
> Martin, HS0ZED
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Rsoifer@aol.com
> Sent: 11 June 2010 22:38
> To: tentec@contesting.com
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>
> John,
>
> Funny thing about that. With the mode set to AM, when I hit Tune and then
> Pwr I get full output like you did, but if I hit the PTT button instead, all
> I get is 11 watts on the Bird. It worked fine with 2.041XT.
>
> 73 Ray
>
>
>
>
> In a message dated 6/11/2010 3:22:43 P.M. GMT Standard Time,
> wb4qda@yahoo.com writes:
>
> Ray
> I just tested my O2 on AM max output was 80 warrs on an Alpha watt meter
> also about the same reading on a LP-100A watt meter with the Power set to
> 100% using the new fearmware version 2.044A
> 73
> John wb4qda
>
>
> ----- Original Message ----
> From: "Rsoifer@aol.com"<Rsoifer@aol.com>
> To: ronc@sonic.net; w5pny@arrl.net; tentec@contesting.com
> Sent: Fri, June 11, 2010 8:36:18 AM
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>
> Ron,
>
> The NR problem has been fixed (!) but the old low-output problem on AM is
>
> back. Mine measures 11 watts carrier power, max. It worked fine with
> 2.041XT.
>
> 73 Ray W2RS
>
>
> In a message dated 6/11/2010 2:17:05 A.M. GMT Standard Time, ronc@sonic.net
> writes:
>
> I have adjusted the "Wish List" for the Orion II to reflect the newest
> version of the firmware. It's at www.N6IE.com
>
> Ron N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: "Harry G McGavran Jr"<w5pny@arrl.net>
> To:<tentec@contesting.com>
> Sent: Thursday, June 10, 2010 5:50 PM
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>
>
>>
>> With this one I can set the side-tone level all the way
>> up to 65 before the pops begin, and by the time one
>> gets past 80 on towards 99 the distortion on the
>> side-tone is still really bad -- BUT -- for me at
>> least, levels are 50-60 are all I need and that is
>> now distortion free, at least with a 610 Hz sidetone
>> which is the only one I tested or use. I also am
>> using the speaker and not headphones for this.
>> Since one gets the side-tone every time the SPOT
>> button is used, the side-tone distortion was really
>> objectionable with 2.043B.
>>
>> The NR seems better too, but most all the time I don't
>> really need it -- and it's nice not to have artifacts that
>> sound like NR action on the side-tone which the side-tone
>> is set to 50-60.
>>
>> There are a few CAT wierdnesses here and there, but the reliability
>> of sending a strings of "*" commands seems better.
>>
>> Unless something else crops up, I think I can live with this
>> release...
>>
>> 73 --
>>
>> Harry, W5PNY
>>
>>
>>
>>
>>
>> --
>>
>> Harry G. McGavran, Jr.
>>
>> E-mail: w5pny@arrl.net
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|