John,
To my ears, the new NR in 2.044A works better than 2.039D, but I recognize
that that is subjective. Otherwise, you're right: it's mainly about the
sweep display, which I never used much anyway. I never had a 565 Orion, so
I can't comment about 1.372.
73 Ray W2RS
In a message dated 6/11/2010 3:56:49 P.M. GMT Standard Time,
fraz1@bellsouth.net writes:
So, please help me understand.....
Other than fixing the sweep "picture", what did this upgrade provide over
39d? I personally had no issues with 39d, and felt the NR was excellent.
My only "real" request would be that the AGC circuit go back within the
DSP
loop as it was in 1.372.
Thanks folks..........
John W4II
----- Original Message -----
From: <Rsoifer@aol.com>
To: <tentec@contesting.com>
Sent: Friday, June 11, 2010 10:38 AM
Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
> John,
>
> Funny thing about that. With the mode set to AM, when I hit Tune and
> then
> Pwr I get full output like you did, but if I hit the PTT button instead,
> all I get is 11 watts on the Bird. It worked fine with 2.041XT.
>
> 73 Ray
>
>
>
>
> In a message dated 6/11/2010 3:22:43 P.M. GMT Standard Time,
> wb4qda@yahoo.com writes:
>
> Ray
> I just tested my O2 on AM max output was 80 warrs on an Alpha watt
meter
> also about the same reading on a LP-100A watt meter with the Power set
to
> 100%
> using the new fearmware version 2.044A
> 73
> John wb4qda
>
>
> ----- Original Message ----
> From: "Rsoifer@aol.com" <Rsoifer@aol.com>
> To: ronc@sonic.net; w5pny@arrl.net; tentec@contesting.com
> Sent: Fri, June 11, 2010 8:36:18 AM
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>
> Ron,
>
> The NR problem has been fixed (!) but the old low-output problem on AM
is
>
> back. Mine measures 11 watts carrier power, max. It worked fine with
> 2.041XT.
>
> 73 Ray W2RS
>
>
> In a message dated 6/11/2010 2:17:05 A.M. GMT Standard Time,
> ronc@sonic.net
> writes:
>
> I have adjusted the "Wish List" for the Orion II to reflect the newest
> version of the firmware. It's at www.N6IE.com
>
> Ron N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: "Harry G McGavran Jr" <w5pny@arrl.net>
> To: <tentec@contesting.com>
> Sent: Thursday, June 10, 2010 5:50 PM
> Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released
>
>
>>
>> With this one I can set the side-tone level all the way
>> up to 65 before the pops begin, and by the time one
>> gets past 80 on towards 99 the distortion on the
>> side-tone is still really bad -- BUT -- for me at
>> least, levels are 50-60 are all I need and that is
>> now distortion free, at least with a 610 Hz sidetone
>> which is the only one I tested or use. I also am
>> using the speaker and not headphones for this.
>> Since one gets the side-tone every time the SPOT
>> button is used, the side-tone distortion was really
>> objectionable with 2.043B.
>>
>> The NR seems better too, but most all the time I don't
>> really need it -- and it's nice not to have artifacts that
>> sound like NR action on the side-tone which the side-tone
>> is set to 50-60.
>>
>> There are a few CAT wierdnesses here and there, but the reliability
>> of sending a strings of "*" commands seems better.
>>
>> Unless something else crops up, I think I can live with this
>> release...
>>
>> 73 --
>>
>> Harry, W5PNY
>>
>>
>>
>>
>>
>> --
>>
>> Harry G. McGavran, Jr.
>>
>> E-mail: w5pny@arrl.net
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
----------------------------------------------------------------------------
----
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2931 - Release Date: 06/11/10
06:35:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|