These are the changes in 2.043B as noted by TT:
Version 2.043B June 3, 2010
Combined code from 2.042E and 2.039d to create this version.
6Hz error correction between main and sub
New NR algorithm
New S-Meter Calibration
Fixed User Recall bug that caused multi-knob focus to lose highlight
Increased 60m band to 5450 kHz
Save PBT to band register
Corrected bug in Band change bandwidth recall using remote POD.
Changed the way Step selection was handled for main Vs sub assignments.
Added patch to audio routine that correct ant2 relay problem when audio
selection changes
Added patch to CAT interface 'U' routine that correct ant2 relay problem when
audio selection changes
Corrected AN/NR/MN/NB crashing problem
Removed break in red line at center of screen.
Added forced master reset when first run. This was needed because RAM
allocation changed with PBT
addition to band register.
Sweep Display positions recalibrated
Aligned labels for all the SWEEP widths in the RX menu.
73
Fotis SV8ING Papadellis
GREECE
--- Στις Πέμ., 03/06/10, ο/η Henry, John <jhenry@tentec.com> έγραψε:
Από: Henry, John <jhenry@tentec.com>
Θέμα: [TenTec] Orion 2 Firmware 2.043B Released
Προς: tentec@contesting.com
Ημερομηνία: Πέμπτη, 3 Ιούνιος 2010, 14:19
Based on customer inputs we have just released new Orion 2 Firmware.
Version 2.043B. Extensive testing was done with several beta testers
to ensure that this release is valuable and reliable. Many problems
were resolved, and some features were re-written. So there may be
instances where some features don't operate or perform exactly as you
are use to in the previous released firmware. For example, the Noise
Reduction algorithm has been redone. Under some conditions, a NR level
of 1 may produce what appears to be pops in the audio. This is
actually still some of the noise getting through. But as you increase
the aggressiveness of the NR, the pops will go away and so will the
noise floor. Different types of noise and different signal strengths
of the recovered audio will warrant different aggressiveness levels.
Thank you for your patience, and as always comments are welcome, just
send an email to ditsnbits@tentec.com.
Thanks
John Henry, KI4JPL
TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|