Many thanks, John. I've installed it and will give it a whirl.
73,
Ray W2RS
In a message dated 6/3/2010 2:27:24 P.M. GMT Standard Time,
jhenry@tentec.com writes:
Based on customer inputs we have just released new Orion 2 Firmware.
Version 2.043B. Extensive testing was done with several beta testers
to ensure that this release is valuable and reliable. Many problems
were resolved, and some features were re-written. So there may be
instances where some features don't operate or perform exactly as you
are use to in the previous released firmware. For example, the Noise
Reduction algorithm has been redone. Under some conditions, a NR level
of 1 may produce what appears to be pops in the audio. This is
actually still some of the noise getting through. But as you increase
the aggressiveness of the NR, the pops will go away and so will the
noise floor. Different types of noise and different signal strengths
of the recovered audio will warrant different aggressiveness levels.
Thank you for your patience, and as always comments are welcome, just
send an email to ditsnbits@tentec.com.
Thanks
John Henry, KI4JPL
TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|