If its not been opened up, then it has the 15 meter low pass filter on
the input board just like the schematic shows. I still think the problem
is with that filter or its connections to make a tuned circuit at 40
meters. Check that sub board's grounds.
73, Jerry, K0CQ
On 6/2/2010 2:15 PM, Kris Merschrod wrote:
> Good afternoon everyone who has been feeding me solid possible fixes. No
> solution yet. This AM I decided to focus on the inside of the AMP instead
> of outside fixes. So it is on the bench, opened up, dusted and vacuumed out
> and, having checked the wafer switch contacts am about to do a careful
> "de-oxing" of the contacts to be sure that contact is being made on both
> sides. The components all seem sound and not heat stained. There is
> continuity to the Shunt Board and to the coils.
>
> (I'm also going to open up the 10 meter position - but I have to write to TT
> for those instructions. After all, somebody has to ironize the E-layer or
> this new sunspot cycle will never begin!)
>
> I will keep you posted. MY TNX
>
> Kris KM2KM
> Merschrod
> 123 Warren Road
> Ithaca, NY 14850
> www.merschrod.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|