To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem |
From: | Ken Brown <ken.d.brown@hawaiiantel.net> |
Reply-to: | ken.d.brown@hawaiiantel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Mon, 31 May 2010 11:37:08 -1000 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
> The problem of mismatch is often the result of the use of two or more finals > in the amplifier and their resulting parallel input impedance, and the use of > a solid state driver with a non tunable final transmitter stage. And the failure to include an input tuned circuit to transform the input impedance to 50 ohms, so that any length of coax would work equally well. DE N6KB _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Mike Schatzberg |
---|---|
Next by Date: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Jim Brown K9YC |
Previous by Thread: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Mike Schatzberg |
Next by Thread: | Re: [TenTec] Ten-Tec 411 Centaur Amp Problem, Jim Brown K9YC |
Indexes: | [Date] [Thread] [Top] [All Lists] |