Got the set up to work on Windows 7, even with Power SDR but I don't need it
for the band scope
I would use it to split out the frequency readouts and controls to multiple
logging programs, N1MM/N3FJP/DXBase
It's cool with K3 All the logging programs and Power SDR, just didn't know it
could be done with Orion or ICOM through N4PY...
Best Wishes
Richard
From: rick.williams@telus.net
To: rdetweil@hotmail.com
Subject: Re: [TenTec] Orion 2/N4PY/LP-Bridge/Power SDR-IF
Date: Sat, 27 Mar 2010 17:41:04 -0700
Richard if you go the LP-PAN panadapter route you need to extract the 9 MHz IF
out of the Orion. The mod is on my website. If you choose the SDR-1000(?)
route it's on Carl's website.
73,
Rick
VE7TK
Personal Website: http://www3.telus.net/ve7tk
BC Swap Net: http://bcswap.webs.com/
To:
<n4py2@earthlink.net>, <tentec@contesting.com>
Subject:
Re: [TenTec] Orion 2/N4PY/LP-Bridge/Power SDR-IF
From:
Richard Detweiler <rdetweil@hotmail.com>
Reply-to:
Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date:
Sat, 27 Mar 2010 17:44:01 -0500
List-post:
<tentec@contesting.com">mailto:tentec@contesting.com>
Cool, I'll try it.
Best Wishes
Richard
谢谢 理查
> From: n4py2@earthlink.net
> To: tentec@contesting.com
> Date: Sat, 27 Mar 2010 13:04:15 -0400
> Subject: c>
> All my versions have this capability.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|