The ALC set does not calibrate the meter, it will adjust the maximum output.
Pse see the procedure on my website. Mike W2AJI
-----Original Message-----
From: shristov
Sent: 2/7/2010 9:48:11 PM
To: Discussion of Ten-Tec Equipment
Cc: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Orion 2 output power
Adjust the ALC SET pot (R179) on the A5 IF Board, beneath the speaker.
73,
Sinisa YT1NT, VE3EA
----- Originalna poruka -----
Pošiljalac: Steve Narducci <steve@ndwave.com>
Datum: Nedelja, Februar 7, 2010 22:07
Tema: [TenTec] Orion 2 output power
Primalac: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
>
> I picked up a second hand Orion 2 six months ago.
> The output power is off on its reading as I am sure the previous owner
> played with this.
> While reading 65 watts it really puts out 100W.
> It will go way above 100W if I run her up.
> However, I really want to bring it back into specs.
> Anyone have a how-to guide on doing that?
>
> Thanks in advanced!
>
> Steve W9SN
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|