To: | "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
---|---|
Subject: | [TenTec] Orion 2 output power |
From: | "Steve Narducci" <steve@ndwave.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Mon, 8 Feb 2010 16:06:54 -0500 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I picked up a second hand Orion 2 six months ago. The output power is off on its reading as I am sure the previous owner played with this. While reading 65 watts it really puts out 100W. It will go way above 100W if I run her up. However, I really want to bring it back into specs. Anyone have a how-to guide on doing that? Thanks in advanced! Steve W9SN _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] ALC & the Omni VI, Jim Brown K9YC |
---|---|
Next by Date: | Re: [TenTec] Orion 2 output power, Mike Schatzberg |
Previous by Thread: | Re: [TenTec] ALC & the Omni VI, Jim Brown K9YC |
Next by Thread: | Re: [TenTec] Orion 2 output power, shristov |
Indexes: | [Date] [Thread] [Top] [All Lists] |