| To: | k0bx@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Centurion 422 Amp HV - 2800 V S/B 3100??? |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 03 Dec 2009 16:16:37 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
My fairly new example indicates at least 3100 V when I use the Ep meter reading. Does this help, or did I not get the correct setting? ======== K8JHR ================= k0bx@arrl.net wrote: > I have an older Centurion 422 Amp. About a 1996 build date. > My Plate Voltage shows 2800 Volts no load. > The manual said it should be 3100 Volts. > > _______________________________________________ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] FS: Orion 565, Kevin McGuirt |
|---|---|
| Next by Date: | Re: [TenTec] Centurion 422 Amp HV - 2800 V S/B 3100???, pfizenmayer |
| Previous by Thread: | [TenTec] Centurion 422 Amp HV - 2800 V S/B 3100???, k0bx@arrl.net |
| Next by Thread: | Re: [TenTec] Centurion 422 Amp HV - 2800 V S/B 3100???, pfizenmayer |
| Indexes: | [Date] [Thread] [Top] [All Lists] |