TenTec
[Top] [All Lists]

Re: [TenTec] Updated "FIX IT" list for Orion II v. 2.041XL

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Updated "FIX IT" list for Orion II v. 2.041XL
From: steve r <n8isaham@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 21 Nov 2009 21:55:44 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Does anyone know if the orion II lcd screen is compatiable with orion I

It would be nice to have it as an upgrade swap. 

Just courious , Steve N8IS



________________________________
From: Ron Castro <ronc@sonic.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Sat, November 21, 2009 7:39:49 PM
Subject: [TenTec] Updated "FIX IT" list for Orion II v. 2.041XL

I avoided getting into the recent food-fight on this reflector about 
problems with the Orion and Orion II firmware since the volley seemed more 
emotional than objective.  Those of you who know me or have read my posts in 
the past know that I am neither a TT cheerleader nor basher...I report, you 
decide.

Now that the dust has settled and most of the blood has dried, I thought it 
would be good to update the v 2.041XL Fix List on my website.  It can be 
found at:

http://n6ie.com/Wish%20List2.htm

The list below is only about the 2.041XL update for the Orion II.  On the 
web link, you'll find the cumulative wish-list as well.  Here is a summery 
of what I hope TT is working on for the next 'non-beta' release:

  1.  Red Screen problem.  Sweep goes to weird red lines and/or background. 
Big signals were initially thought to be problem, but tests of up to 0 dBm 
could not recreate the problem.  This seems to happen only rarely but it is 
a PITA.
  2. Spot level is many dB below S-Tone level.  They should be about the 
same.  They increased the side tone volume, but forgot about the spot tone, 
which adjusted with the same control.
  3. S-Meter and Sweep do not change while tuning main dial. This bugs me 
more than I thought it would!
  4. Popping on AF AGC (setting AGC constants very slow mitigates but does 
not eliminate problem)
  5. Low level on AF AGC relative to RF AGC of 10 to 20 dB
  6. Reports of "noise crash" on AF AGC when Notch on AN pressed. (Many 
people saw this initially, but it seems to have gone away on its own.go 
figure!)
  7. NR in AF AGC: sounds like it needs more level.

            Ron  N6IE
      www.N6IE.com

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>