Make sure your Monitor level is not set too high. My was and the Heil
picked up the audio from the earpiece.
Jeff (Orion 1)
-----Original Message-----
From: Roger Wise [mailto:jrwise@hbci.com]
Sent: Saturday, November 21, 2009 11:46 AM
To: tentec@contesting.com
Subject: [TenTec] Distortion SSB Omni VII
I am using the Omni VII 588/AT. Firmware V 1027. Microham keyer. WriteLog
contest program. Here is the problem. When I send a contest voice message
from the WriteLog program the audio is perfect. I am monitoring it on a
separate receiver. When I transmit direct using a heil pro set/ plus
everything is distorted. I have broken everything down to just a dummy load
with same results. I can clean up the distortion by adjusting the TX
Equalizer to a minus 15 db. Used ddifferent mics and same results.I am
wondering if anyone else out there has this same problem. For the life of
me I don't know when this problem came about. I have run the experiment on
low power as well as high. I changed grounding cables and even taken them
off. No effect. Any help out there. I always had great signal reports
about the audio before.
Thanks Roger KI0F
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|