| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Omni-C Trim ring |
| From: | John Graves <jh.graves@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 01 May 2009 22:28:58 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I now have a trim ring for my semi-naked Omni-C. But How to install it? Can someone describe how it's done? Do I have to remove the top and bottom cover? Thanks, -- John Graves WA1JG jh.graves@verizon.net _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] parts not SS, Charles Harpole |
|---|---|
| Next by Date: | Re: [TenTec] Scotch 33 - Non corrosive RTV, Stuart Rohre |
| Previous by Thread: | [Orion] TenTec Repair Service oher than TenTec?, Joe Giacobello |
| Next by Thread: | Re: [TenTec] Omni-C Trim ring, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |