Go to
http://www.allelectronics.com
and ask for a catalog.
The thing you want is called an ELECTROLUMINESCENT STRIP
ON page 7 of an old catalog, cat# EL-5, and cost a whopping $3.50 !! Get two
and you will have a spare and when you have a spare you will never need
another strip :-) Gompersons law !!
Oh, you will need to drop the front panel, not all the way off, just loosen
the screws after taking off the top and bottom covers ! With the front panel
near the edge of your desk just remove the top side screws and loosen the
bottom side screws if I remember right and it will tilt down enough for you
to see what has to be done. I believe the old strip is a bit longer but it
slides out after you remove the wire powering it and slide the new one it
and attach the wire back up to it ! Bingo , green light for $3.50 ! Good as
new !
Walt K8CV Royal Oak, MI.
----- Original Message -----
From: "Günter" <guenter@dc1ba.org>
To: <tentec@contesting.com>
Sent: Monday, February 02, 2009 4:21 AM
Subject: [TenTec] Argoanaut II/Delta dispaly backlight
> Hello
> can anybody tell me, how can I replace the Backlight of Argonaut II,
> like Bob Towers. What must I do to replace it.
> vy 73 de DC1BA, Guenter
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|