Diodes in the SWR bridge on the LPF board may be leaking.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Jeff" <n3jbh@yahoo.com>
To: <tentec@contesting.com>
Sent: Wednesday, December 17, 2008 7:46 PM
Subject: [TenTec] Omni 6 Opt-3 gaining power out
> Omni 6 Opt-3 gaining power out
>
> Ok I have a rather odd problem. My Omni6 Opt-3 really has two problems I
> guess
> The built in meter is only showing about 60 watts out in any mode I try.
> Yet my trusted external meters show 125 watts out put. The day the
> internal meter started showing me 60 watts is the same time the external
> meters started showing me 125 watts, The rig use to show around 98 watts
> all the time. Any idea whatʼs up?
>
> The power supply reading is close to what I would expect 14 volts @ 18
> amps on cw.
> Perplexed and confused any advice? Jeff
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|