| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Omni 6 Opt-3 gaining power out |
| From: | Jeff <n3jbh@yahoo.com> |
| Reply-to: | n3jbh@yahoo.com, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 17 Dec 2008 16:46:34 -0800 (PST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Omni 6 Opt-3 gaining power out
Ok I have a rather odd problem. My Omni6 Opt-3 really has two problems I guess
The built in meter is only showing about 60 watts out in any mode I try.
Yet my trusted external meters show 125 watts out put. The day the internal
meter started showing me 60 watts is the same time the external meters started
showing me 125 watts, The rig use to show around 98 watts all the time. Any
idea whatʼs up?
The power supply reading is close to what I would expect 14 volts @ 18 amps on
cw.
Perplexed and confused any advice? Jeff
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] [!! SPAM] Re: Orion II firmware release "thisfall"....I hope, waltk8cv4612amos |
|---|---|
| Next by Date: | Re: [TenTec] Omni 6 Opt-3 gaining power out, Phil Chambley Sr. |
| Previous by Thread: | Re: [TenTec] Gonset, EICO etal. Remember this one?, Dave |
| Next by Thread: | Re: [TenTec] Omni 6 Opt-3 gaining power out, Phil Chambley Sr. |
| Indexes: | [Date] [Thread] [Top] [All Lists] |