TenTec
[Top] [All Lists]

[TenTec] TenTec items FS

To: TenTec List at contesting <tentec@contesting.com>
Subject: [TenTec] TenTec items FS
From: "Ken Simpson, W8EK" <W8EK@speakeasy.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 10 Dec 2008 09:20:34 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
TenTec items For Sale:

TenTec 256 FM module
This module adds FM to the Paragon 585 and the
Omni V 562, and maybe others.  It works fine, and
includes cables and all paper work for $75

TenTec 285, 500 Hz filter
500 hz for CW or digital use
Fits Corsairs, Paragons, Omni V and VI, and others.
This one has its paperwork and looks like new.  $70

TenTec 705 desk microphone
This electret desk mic has the 4 pin connector,with
PTT and "hold" buttons.  It works great, and looks
like new.  With paper work for $75.

Scout 555 / Argo 556 Band Modules
Band modules for 40, 30, 20, 17, 15, and 10 meters.
All work fine, and look fine as well.
Non-WARC band modules are $65 each.
WARC band modules (30 and 17 meters) are $70 each.

TenTec 296 mobile mount for 555 Scout or 556 Argo
Nice clam shell type of mount in very good condition.
With paper work for $50

TenTec KR-20 A Electronics Keyer / Paddles
The KR-20 A is a combination of a set of CW paddles and
the electronic keyer combined all in a single unit.
This unit will operate from either 120 V AC, or from
13 V DC. The electronic portion includes speed control,
plus an internal weighting control. Sidetone is also
included, and it will key both positive and negative
voltages with its reed relay output. It also has a
special "tune button" on the top that can be used as
an aid in adjusting your rig or antenna tuner, or it
can be used as a straight key.
This particular unit works fine, and looks fine also.
Paper work is included for $50.

"Switcher / 25" 25 amp switching power supply
This is a 25 amp switching power supply in a case that
matches the early Omni series case, with the metal bezel
around it.  It is in a case that is the same size as a 243
remote VFO.  It has an ammeter on the front, along with
Switch, TenTec logo, and output bulb.  The front panel
basically looks like a 280 power supply with a metal bezel,
but says "Switcher/25" on it. It is very quiet, and well
shielded, and does not produce any electrical noise that
I could find. I am not positive if TenTec made this, or if
it is homebrew to look like TenTec.  If it is homebrew, it
certainly is very professionally done.  $150

Heavy duty power supply Pyramid PS-35
This supply is good for 32 Amps Constant or 35 Amps Surge.
The output voltage is adjustable over a 12 to 15 volt
range with a multi turn pot. It has crowbar over voltage
protection, short circuit & thermal protection and features
a pair of nice large edgewise meters to measure output
voltage and output current. There is an internal fan. This
is a very healthy, heavy duty supply!
This particular unit works 100% and looks very close to new.
$135

Power cable for Hercules 444 linear amplifier
This is the heavy cable that goes from the power supply
to the amp. It has a heavy duty 9 pin molex type
connector on both ends, and multiple runs of either
#12 or #14 wire, and is about 6 feet long.
It is in good shape. $18


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK@speakeasy.net or W8EK@arrl.net
Voice Phone  (352) 732-8400
















_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] TenTec items FS, Ken Simpson, W8EK <=