There are at least two different T/R switching configurations for
Corsair II radios. Mine is an earlier model, which does not have the
connections for key in and key out. The later versions do have these
connections. There is a mod published to install these ports in the
older units. The manual I have here for my Centaur amp gives hook up
info for both versions. I have not tried it out yet, since I have not
had the time to wire in the 220 volt line for the amp, yet.
Dr. Gerald N. Johnson wrote:
On Tue, 2008-12-09 at 19:28 -0500, Gary Smith wrote:
On 9 Dec 2008 at 19:24, Tim Heasman wrote:
Hi Tim,
I'll do that. Any suggestion as to SSB connections?
Thnks,
Gary
KA1J
Nah, that's wrong. Key the Corsair. Take out the jumper on the back that
connects Key Out to Key In. Hook Key out on the Corsair to Key in on the
amp and Key Out on the amp to Key In on the Corsair. Works for all modes
then and waits to key the Corsair until the PA is ready for RF.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.15/1839 - Release Date: 12/9/2008 9:59 AM
|