TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II Display problem HELP

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II Display problem HELP
From: <gsanderlin@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 20 Aug 2008 19:20:35 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Check for plugs that might be plugged in, but not aligned properly. Check for 
pins that might have pushed out when connectors were plugged in.  Also check 
the other end of the cables to make certain they didn't get unplugged.

Hope this helps

Gary
---- ARDUJENSKI@aol.com wrote: 
> PROBLEM: The Paragon II display board is set with a series of "7's" in its  
> display
>  
> I replaced the rocker ON/OFF switches on both the 961 PS and the PARAGON  II. 
> I replaced the PS switch first and the units worked fine. Then I  decided to 
> replace the PARAGON II switch. I removed the top and bottom clamshell  covers 
> then loosened the side screws for the front panel then slowly and  carefully 
> rotated the front panel forward to gain access to the back of the  rocker 
> switch. The base of the PARAGON II was propped  about 2 inches to  allow free 
> rotation of the front panel. The ON/OFF rocker switch was replaced  without 
> incident and a check of all connectors was made to ensure they were all  
> seated and 
> no wires pulled away.  When energizing the unit the DISPLAY  showed only a 
> series of "7's" which did not change. I rotated the tuning knob  and a few 
> "7's" 
> blinked but nothing else. I tried cycling off and on a few times  with 
> waiting 
> period in between but no changes.
>  
> The radio does receives.
>  
> I went back a second time removing all the connectors on the front panel  and 
> top boards and cleaned with DE-OXITE with a sprayed Q-Tip and reseated  them. 
>  
>  
> TEN TEC: I did contact Ten Tec Service and was advised to check the  
> connectors (which I did) and it not would would need to see some bench time 
> to  figure 
> it out.
>  
> Before I box this up for that trip to Ten Tec I was hoping someone else may  
> have experience this problem and has a solution. Is there some other tests or 
>  
> checks or maybe a RESET?
>  
> I appreciate your help.................Alan  KB7MBI
> 
> 
> 
> **************It's only a deal if it's where you want to go. Find your travel 
> deal here.      
> (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>